we are getting to install the new donuts and we are doing the
'pre-compression' procedure as outlined by AEC. i understand that this will
put an initial 'set' on the donut stack. the Maint. manual talks about the
disks taking a set and the effect on the free play seen after the set and
not to adjust the nut for the clearance set at install. My question is do i
use the same value shown for the nut adjustment after doing the procedure
outline by AEC.



Mike Dawson

_______________________________________________
BAC-Mail mailing list
BAC-Mail@beechaeroclub.org
http://www.beechaeroclub.org/mailman/listinfo/bac-mail